產品說明0
※本產品原廠代理從國外進口，有些交期較長，下訂前請詢問！
SparkFun Arduino ProtoShield - Bare PCB
DEV-13819
DESCRIPTION
The SparkFun Arduino ProtoShield is a bare PCB with no attached or included parts that lets you customize your own Arduino shield using whatever circuit you can come up with! You will even be able to test your circuit or project to make sure everything is working the way it should! The SparkFun Arduino ProtoShield is based off the Arduino R3’s footprint that allows you to easily incorporate it with favorite Arduino-based device.
Now you don’t need to buy the whole ProtoShield kit if you just need a piece of prototyping board that will fit on top of your Arduino. You might want to grab a stackable header kit, though, which you can find in the related items below.
One of our favorite features with this version of the Arduino ProtoShield is the solderable-like breadboard prototyping area! Half of this area was designed with a breadboard in mind. On the underside of the shield you will be able to see open jumper pads between each through hole to make a connection like a breadboard. Once you add a component, simply add a solder jumper between holes to make a connection. For those that prefer the standard prototyping pads, we left the other side (near the BlueSMiRF and Serial UART ports) as is.
We have also moved the prototype testing components (those used to make sure your circuit works effectively) off of the “mainland” of the shield and onto a ProtoSnap styled, removable PCB. On this test area you will find soldering areas for two 3mm LEDs (as well as pins to control and power them), two 330 Ohm resistors, a 10K Ohm resistor, and a pushbutton. These items you’ll need to purchase separately.
FEATURES
- Arduino R3 Footprint
- Solderable-Like Breadboard
- BlueSMiRF or Comparable 6-pin Pins
- Detachable Test Area
DOCUMENTS
==============
(以下有舊款資訊 供參考)
Arduino ProtoShield - Bare PCB(DEV-11665)
Description: By popular request, we're selling the always-handy ProtoShield PCB on its own! Originally spawned with collaboration between the folks at SFE and ITP @ NYU, the ProtoShield mates with an Arduino development board and gives the user a small soldering area, two general LED footprints, access to a BlueSMiRF socket, a general pushbutton switch footprint, and most important of all - the Arduino reset switch is brought to the top level.
Now you don't need to buy the whole ProtoShield kit if you just need a piece of prototyping board that will fit on top of your Arduino. You might want to grab a stackable header kit, though, which you can find in the related items below.
Documents:
- Schematic
- Eagle Files
- ProtoShield Wishlist
- Arduino Home Page
