德源科技 
德源科技德源科技
公司簡介訂購方式匯款確認檔案下載 聯絡我們保固說明訂單查詢討論區
電子郵件:

密碼:

忘記密碼
加入會員
  首頁 | 原廠 Arduino® | 特殊服務設計 | 轉接座及轉接板/麵包板 | 開發板/燒錄器/模擬器 | 相容 For Arudino® 週邊及配件 | OKdo系列 | Saleae 系列 | Adafruit 系列 | ArduCam 系列 | Camera 攝像頭 | ROCK 系列 | Debix系列開發板 | Raspberry Pi 樹莓派 | Banana Pi 香蕉派 | BeagleBone 狗骨頭 | M5Stack系列 | Micro:bit (BBC)系列 | NVIDIA Jetson Nano系列 | Pololu 系列 | Pycom 系列 | Seeed 系列 | Sparkfun 系列 | WeMos 系列 | 傳感器 | Cubieboard/CubieTruck系列 | Firefly 系列 | Microduino系列 | Orange Pi 香橙派 | PCB板 | PLC 系列 | Robot 機器人 | UDOO 系列 | RedBearLab 系列 | LattePanda系列 | LittleBits 系列 | Libelium 系列 | Luxonis 相機系列 | PCduino | RobotElectronics 系列 | MageDok 顯示屏 | LCD/LCM/TFT/LVDC | Dimension Engineer 系列 | 通訊模組 | 影音器材(含轉換器) | 線材/連結器/轉換器 | 測量儀器 | 馬達/馬逹控制器/電源模組 | 其他 | 焊接/維修工具 | IC零件 | LED燈-裝飾燈 | 工作站迷你電腦 mini PC | 擴大器 | 雕刻機 | 電池 | 電腦周邊 | 檢定考套件 | 停售商品
  首頁 » 商品目錄 » Raspberry Pi 樹莓派 » 擴展板 » 20927317
商品搜尋 進階
 |  購物車內容  |  結帳   
商品分類
  *Pi 主板*
  *SD卡
  ✨Pi5 B系列 (配件不共用) Type-C 供電
  *供電擴展板UPS(含電池、不含電池)
  ✨Pi 4 B系列 (配件不共用) Type-C 供電
  *Arducam原廠(攝像頭、擴展板)
  *風扇、散熱
  ✨Pi CM 系列 Raspberry Pi Compute
  ✨Pi Pico 系列(micro USB供電)
  ✨Pi Zero、Zero W 系列(micro USB供電)
  *PICAN 擴展板
  Pi Camera攝像頭、外殼、支架
  Pi LCD LED 屏
  ✨Pi 1、2B、3B+(共用電源)micro USB供電
  ✨Pi 400 系列(Type-C USB供電)
  傳感器模組
  小車 智能車 Car
  擴展板
    多功能擴展板 X系列
  網卡(USB、WiFi ....)
  鍵盤/遙控器/手把 手柄
  音頻/功放/喇叭
  Pi 3A+ Case 外殼
  DEXTER原廠
  乙太網
  Allo系列
  Pimoroni系列
  ◎總覽
  其它
  Pi 1B板專用:擴展板/模組/外殼 26PIN
  Book書
Arduino
Pololu
Seeed
Sparkfun
robot-electronics
dimensionengineering
libelium
adafruit
udoo
redbearlab
Arducam
goembed
Saleae
okdo
服務台
公司簡介
退換貨服務
訂購方式
聯絡我們
匯款確認
[<< 前一頁]  瀏覽相同分類產品 60 / 207  [下一頁 >>]
●USB Switch and Multiplexer,雙microUSB接口、適用樹莓派、Arduino
NT$940
運費NT$50
條碼20927317
產品說明1

※本產品原廠代理從國外進口,有些交期較長,下訂前請詢問!

USB Switch and Multiplexer

兼容:RPi 3B、3B+、RPi 4B、RPi Zero 2

  The USB Switch/Multiplexer allows a USB device (or multiple devices if connected via a USB hub) to be switched between two hosts, or powered off. This newer 4-pin version adds a 3.3V output which can be used to toggle the state using switches without the need for external power./USB 開關/多路復用器允許一個 USB 設備(或多個設備,如果通過 USB 集線器連接)在兩個主機之間切換,或關閉電源。 這個較新的 4 針版本 增加了一個 3.3V 輸出,可用於使用開關切換狀態,而無需外部電源。
  For example, to test images on a Raspberry Pi you can use it to switch a USB flash drive between being the USB boot device on one Raspberry Pi and switching it to a second Raspberry Pi where you could write a new Raspberry Pi OS image, read/write data etc. The switch can handle loads of up to 2.5A.
  Whilst there are many USB 2 Multiplexers available to share a device between USB hosts, the folks at 8086 wanted a board they could easily connect and control from a Raspberry Pi or Arduino and allow power to the device to be turned off.

To control which host the USB port is connected to, set the OE and S (SELECT) pins high/low as per the table below:
!OE SELECT Connection
0 0 USB Type-A is connected to micro USB port A
0 1 USB Type-A is connected to micro USB port B
1 X Disconnected

Both !OE and SELECT are pulled low on the board so that micro-USB port A is connected by default.
The pins can be controlled by 3.3v signals but they're also 5v tolerant. When switching between hosts A/B both data and power for the USB device are connected to that host. Using only the SELECT pin you can switch the device between A/B USB hosts.
Using only the !OE pin it can be used as a USB Switch to turn on/off the USB device (disconnecting both power and data) if you need to power cycle/power down a USB device for example to reset or save power.
By using both !OE and SELECT you have full control over which USB host the device is connected to and power it on/off.
This newer 4-pin version of the USB Switch/Multiplexer adds a 3.3 Volt output which can be used to toggle the state using switches without the need for external power.

 

產品圖片

 

問與答

目前沒有任何商品問答!
本商品上架日期:2013-07-05.
評價
建議購買的商品清單!可以參考看看喔
新版WT588D 下載器,mini燒錄器,編程器(不含WT588D-16P)
新版WT588D 下載器,mini燒錄器,編程器(不含WT588D-16P)
●ESP32 OLED模塊 ESP32 for WiFi和藍牙 ESP8266 ESP-32S ESP-32
●ESP32 OLED模塊 ESP32 for WiFi和藍牙 ESP8266 ESP-32S ESP-32
●Blueduino Rev2 藍芽 Arduino compatible pius BLE CC2540(317030031)
●Blueduino Rev2 藍芽 Arduino compatible pius BLE CC2540(317030031)
購物車 更多
空的...
查詢訂單狀態
 
請輸入您的訂單編號
商品通知狀態 更多
通知●USB Switch and Multiplexer,雙microUSB接口、適用樹莓派、Arduino
更新時通知我
推薦給朋友
 
推薦這個商品給朋友

聯絡方式:手機:0933807110 或 0968222607
E-mail:[email protected](主要信箱) & [email protected](次要) & [email protected] & [email protected] & [email protected]